adviceLUNA / TRQer Support
[Abnormal operation] BUSY LED keeps blinking in red.
“[Cause]
adviceLUNA performs the self-test in ICE internal circuit when turning on the power.
BUSY LED blinks in red if the results of self-test is error.
[Workaround]
adviceLUNA main unit (AP52x) and probe may not be connected correctly. Make sure that JTAG probe (the dark blue latch) is
correctly connected to advice LUNA.
If you are using a trace model, also make sure that OCD trace probe is correctly connected to adviceLUNA.
This problem may occur at the first operation. (Right after the unpacking) In such cases, install system by APClient tool.
If the problem is not corrected even after doing the above workaround, the unit may be broken. Please contact our support center in such cases.
"
adviceLUNA performs the self-test in ICE internal circuit when turning on the power.
[Workaround]
adviceLUNA main unit (AP52x) and probe may not be connected correctly. Make sure that JTAG probe (the dark blue latch) is
correctly connected to advice LUNA.
If you are using a trace model, also make sure that OCD trace probe is correctly connected to adviceLUNA.
This problem may occur at the first operation. (Right after the unpacking) In such cases, install system by APClient tool.
If the problem is not corrected even after doing the above workaround, the unit may be broken. Please contact our support center in such cases.
"
Please cooperate with the questionnaire
Was this answer stood to the visitor's role?