adviceLUNA / TRQer Support

[Scope of application]
All environments which use microVIEW-PLUS

[Error message]
Error No.46: Symbol is not found.

[Cause]
- This error is shown when operations like dump are executed by using the symbol name not in the debug information file.
- This error is shown when operations like dump are executed by specifying the symbol not in the available scope.
- This error is shown when wrong formula (wrong type specification) is specified with eval command.

[Workaround] - Check to make sure that the symbol name is correct.
- Check to make sure that the symbol is available in that scope.
- Check whether there is no mistake in the formula.

[See also]
See Section 1.9 “Expression" of microVIEW-PLUS User’s Manual (Common Edition). (mvwPLUSe.pdf)

"