adviceLUNA / TRQer Support
Unable to Change Probe
[Scope of application]
microVIEW-PLUS
[Error message]
Unable to Change Probe
[Workaround]
Check the probe connection status.
[Cause]
This error message appears if it is failed to change the probe when changing the probe connection destination.
microVIEW-PLUS
[Error message]
Unable to Change Probe
[Workaround]
Check the probe connection status.
[Cause]
This error message appears if it is failed to change the probe when changing the probe connection destination.
Please cooperate with the questionnaire
Was this answer stood to the visitor's role?