adviceLUNA / TRQer Support
[Question] How to set the reset vector address?
[Answer]
If you have selected the reset vector break, select an address to set a break as a reset vector by using the reset command.
The reset vector address is determined by the condition of VINITHI pin of ARM core.
Configure it based on the configuration of target system.
Select 0x00000000 for the normal vector.
Select 0xFFFF0000 for the high vector.
You can specify a desired address by following the steps below if you want to execute the user program intentionally with reset command, and break it at a certain address.
-For reset vector break, select “Setting".
-For the reset vector address, select “Others".
-Select an address you want to invoke a break.
If you have selected the reset vector break, select an address to set a break as a reset vector by using the reset command.
The reset vector address is determined by the condition of VINITHI pin of ARM core.
Configure it based on the configuration of target system.
Select 0x00000000 for the normal vector.
Select 0xFFFF0000 for the high vector.
You can specify a desired address by following the steps below if you want to execute the user program intentionally with reset command, and break it at a certain address.
-For reset vector break, select “Setting".
-For the reset vector address, select “Others".
-Select an address you want to invoke a break.
Please cooperate with the questionnaire
Was this answer stood to the visitor's role?