adviceLUNA / TRQer Support
[Question] I cannot start up the debugger. What should I do?
[Question]
Debugger cannot start up when “Open the project used at previous session" is selected at the option menu of debugger.
[Cause]
The project used at the previous session may not exist.
[Workaround]
(1)
If there is a project file which have set the automatic start-up, return it to where it was, and then start up microVIEW-PLUS.
That project will be started.
(2)
Setting of automatic startup is saved in the registry key.
Delete the registry key by following steps below. It will not start up automatically after the deletion.
(a) Select Run from the start menu of Windows, and then input regedit.
(b) From the list shown at the left of registry editor, select [HKEY_CURRENT_USER]-[Software]-[YDC]-[microVIEW-PLUS].
Depending on the user who have selected at debugger installation, [HKEY_LOCAL_MACHINE] may be displayed instead of [HKEY_CURRENT_USER]. Select it in accordance with your environment.
(c) You can find [START_PROJECT] in the registry key list at the right side. Paths, which are automatically startup, are recorded here. Select [START_PROJECT] and delete it.
Debugger cannot start up when “Open the project used at previous session" is selected at the option menu of debugger.
[Cause]
The project used at the previous session may not exist.
[Workaround]
(1)
If there is a project file which have set the automatic start-up, return it to where it was, and then start up microVIEW-PLUS.
That project will be started.
(2)
Setting of automatic startup is saved in the registry key.
Delete the registry key by following steps below. It will not start up automatically after the deletion.
(a) Select Run from the start menu of Windows, and then input regedit.
(b) From the list shown at the left of registry editor, select [HKEY_CURRENT_USER]-[Software]-[YDC]-[microVIEW-PLUS].
Depending on the user who have selected at debugger installation, [HKEY_LOCAL_MACHINE] may be displayed instead of [HKEY_CURRENT_USER]. Select it in accordance with your environment.
(c) You can find [START_PROJECT] in the registry key list at the right side. Paths, which are automatically startup, are recorded here. Select [START_PROJECT] and delete it.
Please cooperate with the questionnaire
Was this answer stood to the visitor's role?