adviceLUNA / TRQer Support
[Abnormal operation] Cannot execute the step
"[Details]
Cursor does not move to next machine instruction even though I press the step execution button on the toolbar.
[Information]
Step execution mode may not be set by inst (machine instruction). It may be set by line (source line).
ICE repeats the machine step execution if you execute line step even though the symbol information (source line information) is not registered in microVIEW-PLUS debugger. (Running will be shown on microVIEW-PLUS debugger, and target keeps executing without breaking.)
If it is in running state, forcibly break it once, and then change the step execution mode to inst (machine instruction), after that, execute the step again."
Cursor does not move to next machine instruction even though I press the step execution button on the toolbar.
[Information]
Step execution mode may not be set by inst (machine instruction). It may be set by line (source line).
ICE repeats the machine step execution if you execute line step even though the symbol information (source line information) is not registered in microVIEW-PLUS debugger. (Running will be shown on microVIEW-PLUS debugger, and target keeps executing without breaking.)
If it is in running state, forcibly break it once, and then change the step execution mode to inst (machine instruction), after that, execute the step again."
Please cooperate with the questionnaire
Was this answer stood to the visitor's role?