adviceLUNA / TRQer Support
[Error]Specify filter conditions for trace.
[Scope]
ARM ETM
[Error message]
ICE Error No.f18: Specify filter conditions for trace.
[Cause]
This error is output when both of Trace Filter Condition and Trace Switch on the Trace Filter tab of the Trace Enable/ETM Setup window are not set up as trace conditions although Set Trace Filter Conditions is checked on.
[Workaround]
Make the setting with Trace Filter Condition or Trace Switch.
ARM ETM
[Error message]
ICE Error No.f18: Specify filter conditions for trace.
[Cause]
This error is output when both of Trace Filter Condition and Trace Switch on the Trace Filter tab of the Trace Enable/ETM Setup window are not set up as trace conditions although Set Trace Filter Conditions is checked on.
[Workaround]
Make the setting with Trace Filter Condition or Trace Switch.
Please cooperate with the questionnaire
Was this answer stood to the visitor's role?