adviceLUNA / TRQer Support
[Error]Set Software Break Error
[Scope]
ARM
[Error message]
ICE Error No.8c5: Set Software Break Error
[Cause]
When Accsess to memory is performed to set software-breakpoint, This error might be occured.
• Be sure the area is access-permitted.
• Check if a bus controller is set up correctly.
• Be sure that MMU fault is not caused.
• When using the Linux support library "D2A301(LUNA II)""DLA301(LUNA)" function, please check whether you register the vmlinux symbol registration.
[Workaround]
Please try to use OCD break(status FT) instead of usinng softwaare break.
ARM
[Error message]
ICE Error No.8c5: Set Software Break Error
[Cause]
When Accsess to memory is performed to set software-breakpoint, This error might be occured.
• Be sure the area is access-permitted.
• Check if a bus controller is set up correctly.
• Be sure that MMU fault is not caused.
• When using the Linux support library "D2A301(LUNA II)""DLA301(LUNA)" function, please check whether you register the vmlinux symbol registration.
[Workaround]
Please try to use OCD break(status FT) instead of usinng softwaare break.
Please cooperate with the questionnaire
Was this answer stood to the visitor's role?