adviceLUNA / TRQer Support
[Error]The specified ETM port mode is not supported.
[Scope of application]
ARM
[Error message]
The specified ETM port mode is not supported.
[Cause]
This error is output when you specified ETM port mode not supported.
[Workaround]
Choose MPU → ETM Control from the menu bar of the microVIEW-PLUS. Check the supported port mode that is listed on the Sys. Config. tab.
ICE Error No.F13
ARM
[Error message]
The specified ETM port mode is not supported.
[Cause]
This error is output when you specified ETM port mode not supported.
[Workaround]
Choose MPU → ETM Control from the menu bar of the microVIEW-PLUS. Check the supported port mode that is listed on the Sys. Config. tab.
Please cooperate with the questionnaire
Was this answer stood to the visitor's role?