adviceLUNA II Support
File Open Error
[Scope of application]
microVIEW-PLUS
[Error message]
Executing Command
[Workaround]
Register the symbol and check that relevant source information exists on the symbol display screen.
This error also occurs if the source file assigned to the SDRAM is displayed before initializing the memory (access disabled) or if the link address is incorrectly assigned to the unused area of the memory.
[Cause]
This error message appears if the source cannot be displayed in the step execution.
This error occurs if the symbol is not registered or if the break occurs in an area where no symbol information exists.
microVIEW-PLUS
[Error message]
Executing Command
[Workaround]
Register the symbol and check that relevant source information exists on the symbol display screen.
This error also occurs if the source file assigned to the SDRAM is displayed before initializing the memory (access disabled) or if the link address is incorrectly assigned to the unused area of the memory.
[Cause]
This error message appears if the source cannot be displayed in the step execution.
This error occurs if the symbol is not registered or if the break occurs in an area where no symbol information exists.
| Note |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?