adviceLUNA II Support
What should I do with pins on the board when ETM trace signal is not connected to ETM38 pin connector?
[Question]
I am using ETM38 pin connector (Mictor connector) on the user system as a connector for ICE interface, but there is no ETM trace signal to be connected. What should I do with pins for ETM trace signal on the user system?
[Answer]
Leave it as NC.
If you do not use trace signal for ETM connector, you do not need to connect the pin because ETM trace signal is pull-down processed in the ICE internal circuit.
I am using ETM38 pin connector (Mictor connector) on the user system as a connector for ICE interface, but there is no ETM trace signal to be connected. What should I do with pins for ETM trace signal on the user system?
[Answer]
Leave it as NC.
If you do not use trace signal for ETM connector, you do not need to connect the pin because ETM trace signal is pull-down processed in the ICE internal circuit.
| Note |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?