NETIMPRESS SupportLogin
FAQ
Question：How to rewrite only a part of the flash memory
The specified range can be programmed by changing the setting (FUNC 0) of the execution target area of the device function.
However, since the flash memory can be erased only in block units, the address that can be set by NETIMPRESS can only be set by the first address (First Address) of each block or the last address (Last Address) of the block.
* FUNC 0 can be changed on the Basic Operation screen on the remote controller.
* If FUNC 0 is changed, the ADDRESS WARNING message may appear when the power of NETIMPRESS is turned on or when a folder is selected. The warning can be turned off by setting FUNC 9F.
* In some old Renesas(Hitachi) microcomputers (H8S, SH, etc.), the flash memory may be completely erased when booted in the boot mode of the microcomputer. In this case, you can program only the specified range, but the part that is not written will be erased.
However, since the flash memory can be erased only in block units, the address that can be set by NETIMPRESS can only be set by the first address (First Address) of each block or the last address (Last Address) of the block.
* FUNC 0 can be changed on the Basic Operation screen on the remote controller.
* If FUNC 0 is changed, the ADDRESS WARNING message may appear when the power of NETIMPRESS is turned on or when a folder is selected. The warning can be turned off by setting FUNC 9F.
* In some old Renesas(Hitachi) microcomputers (H8S, SH, etc.), the flash memory may be completely erased when booted in the boot mode of the microcomputer. In this case, you can program only the specified range, but the part that is not written will be erased.
Please cooperate with questionnaire cooperation
Was this answer stood to the visitor's role?