NETIMPRESS SupportLogin
FAQ
Question：How to change the WDT (Watchdog pulse output) control in FR830.
You can change the control of the WDT output by changing the value of address 0CF in Parameter Table 2.
Address 0CF: bit 6 □ ■ □□□□□□
bit6 = 0: Pulse output only when writing is executed (/TICS Low period)
bit6 = 1: Always pulse output
* You will be asked to enter the password when accessing the Parameter Table 2 screen, so enter "AF200".
* If you change the setting value on the Parameter Table 2 screen, click the [OK] button on the right side of the screen to reflect the setting value on the writer.
Address 0CF: bit 6 □ ■ □□□□□□
bit6 = 0: Pulse output only when writing is executed (/TICS Low period)
bit6 = 1: Always pulse output
* You will be asked to enter the password when accessing the Parameter Table 2 screen, so enter "AF200".
* If you change the setting value on the Parameter Table 2 screen, click the [OK] button on the right side of the screen to reflect the setting value on the writer.
Please cooperate with questionnaire cooperation
Was this answer stood to the visitor's role?