NETIMPRESS SupportLogin
FAQ
Question：
The control of WDT output can be changed by changing the value of address 0FB in Parameter Table 2.
Address 0FB: bit 3 □□□□ ■□□□
bit3 = 0: Pulse output only when device function is executed (/TICS Low period)
bit3 = 1: Always pulse output
* When accessing the Parameter Table 2 screen, you will be asked to enter the password, so enter "AF200".
* If you change the setting value on the Parameter Table 2 screen, click the [OK] button on the right side of the screen to reflect the setting value on the writer.
Address 0FB: bit 3 □□□□ ■□□□
bit3 = 0: Pulse output only when device function is executed (/TICS Low period)
bit3 = 1: Always pulse output
* When accessing the Parameter Table 2 screen, you will be asked to enter the password, so enter "AF200".
* If you change the setting value on the Parameter Table 2 screen, click the [OK] button on the right side of the screen to reflect the setting value on the writer.
Please cooperate with questionnaire cooperation
Was this answer stood to the visitor's role?