NETIMPRESS avant / acorde Support
How to change WDT(Watchdog pulse) output mode（Model:FRX821, FRX822, FRX830)）
The WDT output mode can be changed by changing the value of 0CF address in Parameter Table 2.
address 0CF：bit 6 □■□□□□□□
bit6=0 ：Output while programming (while /TICS output period）
bit6=1 ：Always output
*Since you will be prompted to enter a password when accessing the screen of Parameter Table 2, please input "AF200".
*When changing the setting value on the screen of Parameter Table 2, please press the [OK] button at the right end of the screen to reflect the set value on the programmer.
address 0CF：bit 6 □■□□□□□□
bit6=0 ：Output while programming (while /TICS output period）
bit6=1 ：Always output
*Since you will be prompted to enter a password when accessing the screen of Parameter Table 2, please input "AF200".
*When changing the setting value on the screen of Parameter Table 2, please press the [OK] button at the right end of the screen to reflect the set value on the programmer.
update date：2021/08/11
Please cooperate with questionnaire cooperation
Was this answer stood to the visitor's role?