adviceLUNA II Support
[Error]CP15 polling time-out occurred.
[Error message]
CP15 polling time-out occurred.
[Cause] This error is output when the ICE made access to CP15, but could not complete the access within a certain time. [Work Around] - If you are connecting both ETM probe and JTAG probe at the same time, use only either one of the two probes. - Choose MPU → MPU-Specific Settings from the menu bar of the microVIEW-PLUS. Open the User System tab and check if MPU type is set up correctly matching with the MPU of a user system. - Check if the watchdog timer reset has occurred.
CP15 polling time-out occurred.
[Cause] This error is output when the ICE made access to CP15, but could not complete the access within a certain time. [Work Around] - If you are connecting both ETM probe and JTAG probe at the same time, use only either one of the two probes. - Choose MPU → MPU-Specific Settings from the menu bar of the microVIEW-PLUS. Open the User System tab and check if MPU type is set up correctly matching with the MPU of a user system. - Check if the watchdog timer reset has occurred.
| Note | ICE Error No.F42 |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?