adviceLUNA II Support
[Error]ETM register setup error
[Scope]
ARM
[Error message]
ICE Error No.ff8: ETM register setup error [Cause]
This error is output when you failed to set up ETM programming bit.
[Workaround]
- In case the MPU you are using is not implemented with ETM, choose [MPU]-[ETM Control] from the menu bar of the microVIEW-PLUS.
And, open the [Control] tab and select "JTAG" for "ETM Type".
ARM
[Error message]
ICE Error No.ff8: ETM register setup error [Cause]
This error is output when you failed to set up ETM programming bit.
[Workaround]
- In case the MPU you are using is not implemented with ETM, choose [MPU]-[ETM Control] from the menu bar of the microVIEW-PLUS.
And, open the [Control] tab and select "JTAG" for "ETM Type".
| Note |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?