adviceLUNA II Support
Unable to Change Probe
[Scope of application]
microVIEW-PLUS
[Error message]
Unable to Change Probe
[Workaround]
Check the probe connection status.
[Cause]
This error message appears if it is failed to change the probe when changing the probe connection destination.
microVIEW-PLUS
[Error message]
Unable to Change Probe
[Workaround]
Check the probe connection status.
[Cause]
This error message appears if it is failed to change the probe when changing the probe connection destination.
| Note |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?