adviceLUNA II Support
Separate the path to convert and the path after conversion with a semicolon.
[Scope of application]
microVIEW-PLUS
[Error message]
Separate the path to convert and the path after conversion with a semicolon.
[Workaround]
Check the conversion rule and add“;".
[Cause]
This error message appears if the separator character “;" separating the path before conversion and the path after conversion does not exist in the path conversion setup.
microVIEW-PLUS
[Error message]
Separate the path to convert and the path after conversion with a semicolon.
[Workaround]
Check the conversion rule and add“;".
[Cause]
This error message appears if the separator character “;" separating the path before conversion and the path after conversion does not exist in the path conversion setup.
| Note |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?