adviceLUNA II Support
Not allowed to set up source path when using a file output by the converter.
[Scope of application]
microVIEW-PLUS
[Error message]
Not allowed to set up source path when using a file output by the converter.
[Workaround]
Path conversion cannot be set for the converter output file.
[Cause]
This error message appears if the path conversion (“trancepath" command, etc.) is set for the converter output file.
microVIEW-PLUS
[Error message]
Not allowed to set up source path when using a file output by the converter.
[Workaround]
Path conversion cannot be set for the converter output file.
[Cause]
This error message appears if the path conversion (“trancepath" command, etc.) is set for the converter output file.
| Note |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?