adviceLUNA II Support
[Error]Debug target core is not found.
[Scope of application]
ARM Cortex
[Error message]
Debug target core is not found.(DTR).
[Workaround]
• In the case setting the fixed value for “APSel (0-255)" of MPU-specific settings, the value may be wrong.
→ Set the correct setting by reading to Section 25.2 “CoreSight Setting Guide".
• Implement (ROM table entry or preamble/DEVTYPE of debug core) of chip maker may not correct.
→ Contact the chip maker.
• JTAG/SWD clock frequency may too high.
→ Low down “JTAG/SWD clock of MPU-specific setting.
[Cause]
This error is output when debug target core is not found in the APB (AHB) which is specified by “APSel (0-255)" of MPU-specific settings. This error occurs only for Cortex core.
ARM Cortex
[Error message]
Debug target core is not found.(DTR).
[Workaround]
• In the case setting the fixed value for “APSel (0-255)" of MPU-specific settings, the value may be wrong.
→ Set the correct setting by reading to Section 25.2 “CoreSight Setting Guide".
• Implement (ROM table entry or preamble/DEVTYPE of debug core) of chip maker may not correct.
→ Contact the chip maker.
• JTAG/SWD clock frequency may too high.
→ Low down “JTAG/SWD clock of MPU-specific setting.
[Cause]
This error is output when debug target core is not found in the APB (AHB) which is specified by “APSel (0-255)" of MPU-specific settings. This error occurs only for Cortex core.
| Note | ICE Error No.F49 |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?