adviceLUNA II Support
[Error]JTAG polling time-out occurred.
[Scope of application]
ARM
[Error message]
JTAG polling time-out occurred.
[Workaround]
• If you are connecting both ETM probe and JTAG probe at the same time, use only either one of the two probes.
• If the area is an access-prohibited area such as SDRAM unless a bus controller is set up, issue the reset command and set up a bus controller.
• Check if the watchdog timer reset has occurred.
[Cause]
This error is output when the ICE made access to the MPU, but could not complete the access within a certain time.
ARM
[Error message]
JTAG polling time-out occurred.
[Workaround]
• If you are connecting both ETM probe and JTAG probe at the same time, use only either one of the two probes.
• If the area is an access-prohibited area such as SDRAM unless a bus controller is set up, issue the reset command and set up a bus controller.
• Check if the watchdog timer reset has occurred.
[Cause]
This error is output when the ICE made access to the MPU, but could not complete the access within a certain time.
| Note | ICE Error No.1E0F |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?