adviceLUNA II Support
[Error]Cannot find the command link target.
[Scope of application]
microVIEW-PLUS
[Error message]
Cannot find the command link target.
[Workaround]
Start up the debugger that you have specified as a project name when issuing cmdlnk command.
If it is already started up, check the project name again.
[Cause]
This error is shown when the project name specified when issuing cmdlnk command cannot be found.
microVIEW-PLUS
[Error message]
Cannot find the command link target.
[Workaround]
Start up the debugger that you have specified as a project name when issuing cmdlnk command.
If it is already started up, check the project name again.
[Cause]
This error is shown when the project name specified when issuing cmdlnk command cannot be found.
| Note | Error No.994 |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?