adviceLUNA II Support
[Error]Read data parity error occurred.
[Scope of application]
ARM Cortex
[Error message]
Read data parity error occurred.
[Workaround]
• JTAG/SWD clock frequency may too high.
→ Low down “JTAG/SWD clock of MPU-specific setting.
• SWD signal may have a problem.
→Check the signal quality of voltage level and signal waveform (Noise, such as reflection).
[Cause]
This error is output when using SW-DP. MPU cannot receive normally the ICE data. This error occurs only for Cortex core.
ARM Cortex
[Error message]
Read data parity error occurred.
[Workaround]
• JTAG/SWD clock frequency may too high.
→ Low down “JTAG/SWD clock of MPU-specific setting.
• SWD signal may have a problem.
→Check the signal quality of voltage level and signal waveform (Noise, such as reflection).
[Cause]
This error is output when using SW-DP. MPU cannot receive normally the ICE data. This error occurs only for Cortex core.
| Note | ICE Error No.F5B |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?