adviceLUNA II Support
[Error]The specified ETM port size is not supported.
[Scope of application]
ARM
[Error message]
The specified ETM port size is not supported.
[Cause]
This error is output when you specified ETM port size not supported.
[Workaround]
Choose [MPU] - [ETM Control] from the menu bar of the microVIEW-PLUS. Check the supported port size that is listed on the Sys. Config. tab.
ARM
[Error message]
The specified ETM port size is not supported.
[Cause]
This error is output when you specified ETM port size not supported.
[Workaround]
Choose [MPU] - [ETM Control] from the menu bar of the microVIEW-PLUS. Check the supported port size that is listed on the Sys. Config. tab.
| Note | ICE Error No.F12 |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?