adviceLUNA II Support
[Error]Half-rate clocking is not supported.
[Scope of application]
ARM
[Error message]
Half-rate clocking is not supported.
[Cause]
This error is output when the MPU you are using does not support Half-Rate Clocking feature. You cannot use the Half-rate clocking function unless ETM implemented in your MPU supports Half-Rate Clocking feature.
[Workaround]
1.Choose MPU → ETM Control from the menu bar of the microVIEW-PLUS. Check if Half-Rate Clocking is listed as “Supported" on the Sys. Config. tab.
2.Check with a manufacturer of the MPU you are using.
ARM
[Error message]
Half-rate clocking is not supported.
[Cause]
This error is output when the MPU you are using does not support Half-Rate Clocking feature. You cannot use the Half-rate clocking function unless ETM implemented in your MPU supports Half-Rate Clocking feature.
[Workaround]
1.Choose MPU → ETM Control from the menu bar of the microVIEW-PLUS. Check if Half-Rate Clocking is listed as “Supported" on the Sys. Config. tab.
2.Check with a manufacturer of the MPU you are using.
| Note | ICE Error No.F14 |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?