adviceLUNA II Support
[Error]You cannot select Stall Processor, as it is not supported.
[Scope of application]
ARM
[Error message]
You cannot select Stall Processor, as it is not supported.
[Cause]
This error is output when the MPU you are using does not support FIFOFULL function.
You cannot execute Stall Processor unless ETM implemented in your MPU supports FIFOFULL feature.
[Workaround]
• Choose MPU → ETM Control from the menu bar of the microVIEW-PLUS. Check if FIFOFULL is listed as “Supported" on the Config. tab.
• Check with a manufacturer of the MPU you are using.
ARM
[Error message]
You cannot select Stall Processor, as it is not supported.
[Cause]
This error is output when the MPU you are using does not support FIFOFULL function.
You cannot execute Stall Processor unless ETM implemented in your MPU supports FIFOFULL feature.
[Workaround]
• Choose MPU → ETM Control from the menu bar of the microVIEW-PLUS. Check if FIFOFULL is listed as “Supported" on the Config. tab.
• Check with a manufacturer of the MPU you are using.
| Note | ICE Error No.F17 |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?