adviceLUNA II Support
[Error]No sequencer resources of ETM available.
[Scope of application]
ARM
[Error message]
No sequencer resources of ETM available.
Check ETM resources status with the Config. tab of the ETM Control dialog box.
[Cause]
This error is output when the MPU you are using does not support Sequencer function.
[Workaround]
Choose MPU → ETM Control from the menu bar of the microVIEW-PLUS.
Check if Sequencer is listed as “Supported" on the Config. tab.
ARM
[Error message]
No sequencer resources of ETM available.
Check ETM resources status with the Config. tab of the ETM Control dialog box.
[Cause]
This error is output when the MPU you are using does not support Sequencer function.
[Workaround]
Choose MPU → ETM Control from the menu bar of the microVIEW-PLUS.
Check if Sequencer is listed as “Supported" on the Config. tab.
| Note | ICE Error No.F1B |
Please cooperate questionaire cooperation
Was this answer stood to the visitor's role?