NETIMPRESS SupportLogin

1.Create a YCM file on the route of the control module (CF card). (The file name is voluntary, the extension is fixed to .YCM)
※YCM file can be created with F/DF Sheet Generator(AZ482).
　　
* When creating with a text editor, copy and paste the contents of the following creation example and correct the address part to the value you want to set.

＜YCM file example＞
// *******************************************************************
// ETHER_SET_01.YCM
// 2014-04-01
//
// *******************************************************************

[ETHER NET]
ADDRESS=192.168.0.1
PORT=1000
SUBNET MASK=255.255.255.0
GATEWAY=0.0.0.0


2.With the CF card containing the YCM file inserted, turn on the NETIMPRESS.
3.If the IP address already set for NETIMPRESS and the IP address described in the YCM file do not match, "YCM DATA SET?" is displayed on the LCD.
4.When EXE1 or EXE2 button is pressed, the setting described in the YCM file is reflected in NETIMPRESS.
　*For AF320, AF420, AF520, AF520, the EXE1 and EXE2 buttons are buttons with no printing on the key top. The upper side is EXE1 and the lower side is EXE2.
　*When "YCM DATA SET?" is displayed, pressing the RESET button will not reflect the YCM file settings, so "YCM DATA SET?" will be displayed again the next time the power is turned on.

Was this answer stood to the visitor's role?