NETIMPRESS SupportLogin
FAQ
Question：How to change the reset control after writing (in FS718,FS719,FS720,FS728,FS818,FS819,FS828)
The reset (/TRES) control after completion of writing can be changed by changing the value of 0CF address in Parameter Table 2.
address 0C1:bit 4,5 □□■■□□□□
A Mode:It ends with Hi-Z. The flash writing mode is continued and the user application does not operate
B Mode：After the device function is completed, assert reset for a certain period (100ms) to operate the user application
Standard:Low output after completion of writing
*Since you will be prompted to enter a password when accessing the screen of Parameter Table 2, please input "AF200".
*When changing the setting value on the screen of Parameter Table 2, please press the [OK] button at the right end of the screen to reflect the set value on the programmer.
address 0C1:bit 4,5 □□■■□□□□
A Mode:It ends with Hi-Z. The flash writing mode is continued and the user application does not operate
B Mode：After the device function is completed, assert reset for a certain period (100ms) to operate the user application
Standard:Low output after completion of writing
*Since you will be prompted to enter a password when accessing the screen of Parameter Table 2, please input "AF200".
*When changing the setting value on the screen of Parameter Table 2, please press the [OK] button at the right end of the screen to reflect the set value on the programmer.
Please cooperate with questionnaire cooperation
Was this answer stood to the visitor's role?