NETIMPRESS SupportLogin

Trouble Shooting

Error message	CAN ADAPTER ERR
Description	Please check the following points.   1.The target probe selection switch is set to "1" (serial).   → Change the setting to "2" (CAN). 2.The cable is inserted in the connector of TARGET PROBE1. (Serial is enabled.)   → Disconnect the serial cable.   1.The setting of FUNC CD0 is "TARGET PROBE 1".   → Change the setting of FUNC CD0 to "TARGET PROBE 2" or "PROBE SELECT". 2.The setting of FUNC CD0 is "PROBE SELECT" and the cable is inserted in the connector of TARGET PROBE1.   → Disconnect the serial cable.   If the error persists even after performing the above correctly, the programmer main unit may be malfunctioning.
Check item

Back to previous page