NETIMPRESS SupportLogin
FAQ
Search by keyword
Please input a keyword.
Frequently Asked Questions
69 Total 61 ~ 69 page:1・2・3・4・5・6・7
Others Precautions when porting apps created in Visual Basic 6.0 to Visual Basic.NET |
|
In Visual Basic .NET, the names of variables that represent integers have been changed as follows.
Bits Visual [more] |
Remote Controller (AZ490) I want to know the revision content of the remote controller (AZ490) |
|
The main revisions of the remote controller (AZ490) are as follows.
Ver5.72 support Windows 7(32bit)
Ver5.74 Fun [more] |
NETIMPRESS specification Can NETIMPRESS write to multiple microcontrollers simultaneously? |
|
When writing to multiple microcomputers at the same time, even if the target microcomputer is the same type, multiple NE [more] |
Others About regular calibration of flash programmers |
|
Since the flash programmer is not a measuring instrument that requires accuracy, regular calibration is not required.
[more] |
NETIMPRESS specification When using the extended format of CAN ID, the programmer setting and the ID value obtained by the protocol analyzer are different. |
|
The extended format of CAN ID is 29 bit, which is the same as the 11bit base ID (similar to the 11bit when using the sta [more] |
Others NETIMPRESS Glossary |
|
For details, please refer to the link below.
NETIMPRESS Glossary
[more] |
Initial installation I want to change the CAN termination resistance setting on FC839-S2(UCOP). |
|
Start the remote controller (AZ490) and switch to the Parameter Table 2 screen. (You will be asked for a password to acc [more] |
Others About the HS code when exporting products |
|
Programmer products use the following HS and HTS codes. (As of October 2017)
■ HS code
Programmer main unit (AF430 [more] |
Others About AF430 built-in lithium battery |
|
The AF430 has one coin-type lithium battery Panasonic CR1220.
Please refer to the Safety Data Sheet (PSDS) and test sum [more] |
69 Total 61 ~ 69 page:1・2・3・4・5・6・7