NETIMPRESS SupportLogin
FAQ
Search by keyword
Please input a keyword.
Frequently Asked Questions
69 Total 41 ~ 50 page:1・2・3・4・5・6・7
NETIMPRESS specification What settings are stored on the programmer main unit? |
|
The setting values saved in the main unit of NETIMPRESS next are as follows.
1.IP address, port number (FUNC E2 fac [more] |
Parameter settings How to adjust the timing from reset release to TOOL0 rise with FR850 or FR651 |
|
You can adjust the time between reset rising and TOOL0 rising by changing the values of addresses D2 to D3 in Parameter [more] |
NETIMPRESS specification About supporting Windows 8 |
|
Currently, Windows 8 / Windows 8.1 is not supported for all software.
[more] |
NETIMPRESS specification About supporting Windows 10 |
|
Status of various software support for Windows 10 (updated 1/7/2019)
Compatible with Windows 10
AZ490 Ver5.85 or l [more] |
NETIMPRESS specification About Windows 7 compatibility |
|
Windows 7 compatibility status
AZ490(Remote Controller)
AZ481(KEY file generator)
AZ482(F/DF sheet generator)
[more] |
NETIMPRESS specification Can I use a commercially available compact flash (CF card)? |
|
In NETIMPRSS, definition program licenses are managed by a dedicated compact module, so a commercially available CF card [more] |
Parameter settings How to change the ADDRESS WARNING display setting (FUNC 9F) at startup with G-NETIMPRESS. |
|
The ADDRESS WARNING display setting (FUNC 9F) at startup cannot be changed on the AZ490 and must be done standalone.
To [more] |
Others What is the difference between the standard target probes AZ210, AZ410, AZ410A, AZ610? |
|
The AZ410, AZ410A, and AZ610 are compatible with the AZ210 in terms of connector shape and basic pin arrangement, but th [more] |
NETIMPRESS specification I want to know the detailed model name of the IC used in the interface circuit. |
|
The detailed model numbers of the ICs listed in the interface circuit type in the manual are as follows.
VHC125→TC74V [more] |
NETIMPRESS specification How to program only a part of the flash memory |
|
The specified range can be programmed by changing the setting (FUNC 0) of the execution target area of the device func [more] |
69 Total 41 ~ 50 page:1・2・3・4・5・6・7